Coolbot Ee Code. CoolBot Generation 7 WiFi WalkIn Cooler Controller with Air Most codes (6) were provided in Feb of 2025.The best discount (30% off) was offered in Mar of 2025.Over the last 30 days, discount average savings for CoolBot was $14.06, and the most savings was $23.90.; Currently, there are 15 active CoolBot discounts: 11. The CoolBot uses 2 sensors (ROOM and FIN sensors), the HEATER cable (red tip) and a programmed micro-controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between 33°F/0.5°C and 65°F/18°C without freezing up.
50 Off CoolBot Promo Code (+4 Top Offers) Aug 19 — from coolbot.knoji.com
A heater light pulsing slowly is completely normal! That means the CoolBot is trying to keep the Heater Cable warm to "fool" the A/C's temperature sensor and cool the room Most codes (6) were provided in Feb of 2025.The best discount (30% off) was offered in Mar of 2025.Over the last 30 days, discount average savings for CoolBot was $14.06, and the most savings was $23.90.; Currently, there are 15 active CoolBot discounts: 11.
50 Off CoolBot Promo Code (+4 Top Offers) Aug 19 —
The CoolBot uses 2 sensors (ROOM and FIN sensors), the HEATER cable (red tip) and a programmed micro-controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between 33°F/0.5°C and 65°F/18°C without freezing up. Try power-cycling the CoolBot Pro (unplug -wait 6 sec- plug again) 1 During normal operation or after 20 seconds of inactivity the CoolBot goes into the "Room Mode" by default and the display shows the current room temperature
coolbotproject. The CoolBot uses 2 sensors (ROOM and FIN sensors), the HEATER cable (red tip) and a programmed micro-controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between 33°F/0.5°C and 65°F/18°C without freezing up. 1 During normal operation or after 20 seconds of inactivity the CoolBot goes into the "Room Mode" by default and the display shows the current room temperature
DIY WALK IN REFRIDGERATION. Try power-cycling the CoolBot Pro (unplug -wait 6 sec- plug again) Heater light pulsing slowly (or ON) = CoolBot is calling for Cool; Heater light OFF = OFF Cycle; Remember! The Heater Cable is NOT for defrosting the A/C.